Odtnhj

This article includes a list of references, but its sources remain unclear because it has insufficient inline citations. Please help to improve this article by introducing more precise citations. (May 2013) (Learn how and when to remove this template message)

Continuous spectrum

Emission lines (discrete spectrum)

Absorption lines (discrete spectrum)

Absorption lines for air, under indirect illumination, with the direct light source not visible, so that the gas is not directly between source and detector. Here, Fraunhofer lines in sunlight and Rayleigh scattering of this sunlight is the "source." This is the spectrum of a blue sky somewhat close to the horizon, pointing east at around 3 or 4 pm (i.e., Sun toward the west) on a clear day.

A spectral line is a dark or bright line in an otherwise uniform and continuous spectrum, resulting from emission or absorption of light in a narrow frequency range, compared with the nearby frequencies. Spectral lines are often used to identify atoms and molecules. These "fingerprints" can be compared to the previously collected "fingerprints" of atoms and molecules,^[1] and are thus used to identify the atomic and molecular components of stars and planets, which would otherwise be impossible.

Types of line spectra

Continuous spectrum of an incandescent lamp (mid) and discrete spectrum lines of a fluorescent lamp (bottom)

Spectral lines are the result of interaction between a quantum system (usually atoms, but sometimes molecules or atomic nuclei) and a single photon. When a photon has about the right amount of energy to allow a change in the energy state of the system (in the case of an atom this is usually an electron changing orbitals), the photon is absorbed. Then it will be spontaneously re-emitted, either in the same frequency as the original or in a cascade, where the sum of the energies of the photons emitted will be equal to the energy of the one absorbed (assuming the system returns to its original state).

A spectral line may be observed either as an emission line or an absorption line. Which type of line is observed depends on the type of material and its temperature relative to another emission source. An absorption line is produced when photons from a hot, broad spectrum source pass through a cold material. The intensity of light, over a narrow frequency range, is reduced due to absorption by the material and re-emission in random directions. By contrast, a bright emission line is produced when photons from a hot material are detected in the presence of a broad spectrum from a cold source. The intensity of light, over a narrow frequency range, is increased due to emission by the material.

Spectral lines are highly atom-specific, and can be used to identify the chemical composition of any medium capable of letting light pass through it. Several elements were discovered by spectroscopic means, including as helium, thallium, and caesium. Spectral lines also depend on the physical conditions of the gas, so they are widely used to determine the chemical composition of stars and other celestial bodies that cannot be analyzed by other means, as well as their physical conditions.

Mechanisms other than atom-photon interaction can produce spectral lines. Depending on the exact physical interaction (with molecules, single particles, etc.), the frequency of the involved photons will vary widely, and lines can be observed across the electromagnetic spectrum, from radio waves to gamma rays.

Nomenclature

Strong spectral lines in the visible part of the spectrum often have a unique Fraunhofer line designation, such as K for a line at 393.366 nm emerging from singly ionized Ca⁺, though some of the Fraunhofer "lines" are blends of multiple lines from several different species. In other cases the lines are designated according to the level of ionization by adding a Roman numeral to the designation of the chemical element, so that Ca⁺ also has the designation Ca II. Neutral atoms are denoted with the roman number I, singly ionized atoms with II, and so on, so that for example Fe IX (IX, roman 9) represents eight times ionized iron. More detailed designations usually include the line wavelength and may include a multiplet number (for atomic lines) or band designation (for molecular lines). Many spectral lines of atomic hydrogen also have designations within their respective series, such as the Lyman series or Balmer series. Originally all spectral lines were classified into series of Principle series, Sharp series, and Diffuse series. These series exist across atoms of all elements and the Rydberg-Ritz combination principle is a formula that predicts the pattern of lines to be found in all atoms of the elements. For this reason, the NIST spectral line database contains a column for Ritz calculated lines. These series were later associated with suborbitals.

Line broadening and shift

A spectral line extends over a range of frequencies, not a single frequency (i.e., it has a nonzero linewidth). In addition, its center may be shifted from its nominal central wavelength. There are several reasons for this broadening and shift. These reasons may be divided into two general categories – broadening due to local conditions and broadening due to extended conditions. Broadening due to local conditions is due to effects which hold in a small region around the emitting element, usually small enough to assure local thermodynamic equilibrium. Broadening due to extended conditions may result from changes to the spectral distribution of the radiation as it traverses its path to the observer. It also may result from the combining of radiation from a number of regions which are far from each other.

Broadening due to local effects

Natural broadening

The uncertainty principle relates the lifetime of an excited state (due to spontaneous radiative decay or the Auger process) with the uncertainty of its energy. A short lifetime will have a large energy uncertainty and a broad emission. This broadening effect results in an unshifted Lorentzian profile. The natural broadening can be experimentally altered only to the extent that decay rates can be artificially suppressed or enhanced.^[2]

Thermal Doppler broadening

The atoms in a gas which are emitting radiation will have a distribution of velocities. Each photon emitted will be "red"- or "blue"-shifted by the Doppler effect depending on the velocity of the atom relative to the observer. The higher the temperature of the gas, the wider the distribution of velocities in the gas. Since the spectral line is a combination of all of the emitted radiation, the higher the temperature of the gas, the broader the spectral line emitted from that gas. This broadening effect is described by a Gaussian profile and there is no associated shift.

Pressure broadening

The presence of nearby particles will affect the radiation emitted by an individual particle. There are two limiting cases by which this occurs:

• 
  Impact pressure broadening or collisional broadening: The collision of other particles with the emitting particle interrupts the emission process, and by shortening the characteristic time for the process, increases the uncertainty in the energy emitted (as occurs in natural broadening).^[3] The duration of the collision is much shorter than the lifetime of the emission process. This effect depends on both the density and the temperature of the gas. The broadening effect is described by a Lorentzian profile and there may be an associated shift.


• 
  Quasistatic pressure broadening: The presence of other particles shifts the energy levels in the emitting particle,^{[clarification needed]} thereby altering the frequency of the emitted radiation. The duration of the influence is much longer than the lifetime of the emission process. This effect depends on the density of the gas, but is rather insensitive to temperature. The form of the line profile is determined by the functional form of the perturbing force with respect to distance from the perturbing particle. There may also be a shift in the line center. The general expression for the lineshape resulting from quasistatic pressure broadening is a 4-parameter generalization of the Gaussian distribution known as a stable distribution.^[4]

Pressure broadening may also be classified by the nature of the perturbing force as follows:

• 
  Linear Stark broadening occurs via the linear Stark effect, which results from the interaction of an emitter with an electric field of a charged particle at a distance rdisplaystyle r, causing a shift in energy that is linear in the field strength. (ΔE∼1/r2)displaystyle (Delta Esim 1/r^2)
  


• 
  Resonance broadening occurs when the perturbing particle is of the same type as the emitting particle, which introduces the possibility of an energy exchange process. (ΔE∼1/r3)displaystyle (Delta Esim 1/r^3)
  


• 
  Quadratic Stark broadening occurs via the quadratic Stark effect, which results from the interaction of an emitter with an electric field, causing a shift in energy that is quadratic in the field strength. (ΔE∼1/r4)displaystyle (Delta Esim 1/r^4)
  


• 
  Van der Waals broadening occurs when the emitting particle is being perturbed by van der Waals forces. For the quasistatic case, a van der Waals profile^{[note 1]} is often useful in describing the profile. The energy shift as a function of distance^{[definition needed]} is given in the wings by e.g. the Lennard-Jones potential. (ΔE∼1/r6)displaystyle (Delta Esim 1/r^6)
  

Inhomogeneous broadening

Inhomogeneous broadening is a general term for broadening because some emitting particles are in a different local environment from others, and therefore emit at a different frequency. This term is used especially for solids, where surfaces, grain boundaries, and stoichiometry variations can create a variety of local environments for a given atom to occupy. In liquids, the effects of inhomogeneous broadening is sometimes reduced by a process called motional narrowing.

Broadening due to non-local effects

Certain types of broadening are the result of conditions over a large region of space rather than simply upon conditions that are local to the emitting particle.

Opacity broadening

Electromagnetic radiation emitted at a particular point in space can be reabsorbed as it travels through space. This absorption depends on wavelength. The line is broadened because the photons at the line center have a greater reabsorption probability than the photons at the line wings. Indeed, the reabsorption near the line center may be so great as to cause a self reversal in which the intensity at the center of the line is less than in the wings. This process is also sometimes called self-absorption.

Macroscopic Doppler broadening

Radiation emitted by a moving source is subject to Doppler shift due to a finite line-of-sight velocity projection. If different parts of the emitting body have different velocities (along the line of sight), the resulting line will be broadened, with the line width proportional to the width of the velocity distribution. For example, radiation emitted from a distant rotating body, such as a star, will be broadened due to the line-of-sight variations in velocity on opposite sides of the star. The greater the rate of rotation, the broader the line. Another example is an imploding plasma shell in a Z-pinch.

Radiative broadening

Radiative broadening of the spectral absorption profile occurs because the on-resonance absorption in the center of the profile is saturated at much lower intensities than the off-resonant wings.Therefore, as intensity rises, absorption in the wings rises faster than absorption in the center, leading to a broadening of the profile. Radiative broadening occurs even at very low light intensities.

Combined effects

Each of these mechanisms can act in isolation or in combination with others. Assuming each effect is independent, the observed line profile is a convolution of the line profiles of each mechanism. For example, a combination of the thermal Doppler broadening and the impact pressure broadening yields a Voigt profile.

However, the different line broadening mechanisms are not always independent. For example, the collisional effects and the motional Doppler shifts can act in a coherent manner, resulting under some conditions even in a collisional narrowing, known as the Dicke effect.

Spectral lines of chemical elements

Visible light

For each element, the following table shows the spectral lines which show up in the visible spectrum, from about 400nm-700nm.

v t e Spectral lines of the chemical elements
Element	Z	Symbol	Spectral lines
hydrogen	1	H
helium	2	He
lithium	3	Li
beryllium	4	Be
boron	5	B
carbon	6	C
nitrogen	7	N
oxygen	8	O
fluorine	9	F
neon	10	Ne
sodium	11	Na
magnesium	12	Mg
aluminium	13	Al
silicon	14	Si
phosphorus	15	P
sulfur	16	S
chlorine	17	Cl
argon	18	Ar
potassium	19	K
calcium	20	Ca
scandium	21	Sc
titanium	22	Ti
vanadium	23	V
chromium	24	Cr
manganese	25	Mn
iron	26	Fe
cobalt	27	Co
nickel	28	Ni
copper	29	Cu
zinc	30	Zn
gallium	31	Ga
germanium	32	Ge
arsenic	33	As
selenium	34	Se
bromine	35	Br
krypton	36	Kr
rubidium	37	Rb
strontium	38	Sr
yttrium	39	Y
zirconium	40	Zr
niobium	41	Nb
molybdenum	42	Mo
technetium	43	Tc
ruthenium	44	Ru
rhodium	45	Rh
palladium	46	Pd
silver	47	Ag
cadmium	48	Cd
indium	49	In
tin	50	Sn
antimony	51	Sb
tellurium	52	Te
iodine	53	I
xenon	54	Xe
caesium	55	Cs
barium	56	Ba
lanthanum	57	La
cerium	58	Ce
praseodymium	59	Pr
neodymium	60	Nd
promethium	61	Pm
samarium	62	Sm
europium	63	Eu
gadolinium	64	Gd
terbium	65	Tb
dysprosium	66	Dy
holmium	67	Ho
erbium	68	Er
thulium	69	Tm
ytterbium	70	Yb
lutetium	71	Lu
hafnium	72	Hf
tantalum	73	Ta
tungsten	74	W
rhenium	75	Re
osmium	76	Os
iridium	77	Ir
platinum	78	Pt
gold	79	Au
mercury	80	Hg
thallium	81	Tl
lead	82	Pb
bismuth	83	Bi
polonium	84	Po
radon	86	Rn
radium	88	Ra
actinium	89	Ac
thorium	90	Th
protactinium	91	Pa
uranium	92	U
neptunium	93	Np
plutonium	94	Pu
americium	95	Am
curium	96	Cm
berkelium	97	Bk
californium	98	Cf
einsteinium	99	Es

Other wavelengths

Without qualification, "spectral lines" generally implies that one is talking about lines with wavelengths which fall into the range of the visible spectrum. However, there are also many spectral lines which show up at wavelengths outside this range. At the much shorter wavelengths of x-rays, these are known as characteristic X-rays. Other frequencies have atomic spectral lines as well, such as the Lyman series, which falls in the ultraviolet range.

See also

• Absorption spectrum


• Atomic spectral line


• Bohr model


• Electron configuration


• Emission spectrum


• Spectroscopy


• Spectral line ratios


• Fraunhofer line


• Hydrogen line


• Splatalogue


• Table of emission spectrum of gas discharge lamps

Notes

References

Further reading

• 
  Griem, Hans R. (1997). Principles of Plasma Spectroscopy. Cambridge: University Press. ISBN 0-521-45504-9.
  


• 
  Griem, Hans R. (1974). Spectral Line Broadening by Plasmas. New York: Academic Press. ISBN 0-12-302850-7.
  


• 
  Griem, Hans R. (1964). Plasma Spectroscopy. New York: McGraw-Hill book Company.